Adequate Attic Insulation in Bloomington, MN Protects Roofing Materials

by | Oct 23, 2013 | Roofing

Top Stories

Categories

Archives

When homeowners decide to put a new roof on their house, they often want to make it more energy efficient. They should also discuss adding Insulation Bloomington MN at the same time. While the top of their house is under construction, it’s the perfect opportunity to add insulation to their attic space. Twin City Construction roofing specialists are also certified installers of Owings Corning Top of the House Insulation. Just as the name implies, its made to beef up the insulation in the attic. A report produced by the Department of Energy estimates that 80 million homes don’t have enough insulation. That’s a huge waste of oil and gas resources.

It’s important to have well-trained professionals insulate a home. Certified installers have been trained by the manufacturer and have shown that they understand how to use it. The homeowner can trust that they will get the most out of their upgrade by using experienced professionals that participate in training programs. It’s also a good feeling for the homeowner to know that their home meets current building codes. Not only will they save hundreds of dollars each year, they will add thousands of dollars in resale value to their home.

While homeowners might think that a warm attic is a good thing, it can cause problems. A better solution is to insulate the attic and keep the heat in the living spaces. A hot attic without proper ventillation can cause ice dams on the roof that prevent the water from running off into the gutters. This can lead to the roofing materials failing earlier than expected. Hot attics can also cause dampness which leads to insects, mold and mildew.

The roofing contractor will inspect the attic area to determine if additional Insulation Bloomington MN is needed. If the contractor enters the space and can see the joists then the attic is under insulated. Even if the contractor can see insulation, he should use his insulation ruler to determine if there is enough. Usually that means there should be 17 inches of insulation to meet minimum guidelines established by the Department of Energy.